"Make-It Monday": Sealed with Love Note Pad Holder created with NEW Stampin' Up! products All images © 1990-2017 Stampin’ Up!®
Image & page number of the full stamp set and Framelits shown below the project instructions.
Supplies:
- Stamp Sets – Sealed With Love (142815) - the bundle with stamp set and dies is discounted 10% and that special code is 144705
- Papers – Ultra Thick Whisper White Cardstock (140272), Soft Sky Cardstock (131203), Falling in Love Designer Series Paper (142788), Blushing Bride Glimmer Paper (140550)
- Stamp Pads – Sweet Sugarplum (141394)
- Miscellaneous - Big Shot (143263), Sweet & Sassy Framelits (141707), Love Notes Framelits (142752), Mini Paper Clips Combo Pack (142766), Classic Label Punch (141491), ¾” Circle Punch (119873), Blushing Bride Stitched Satin Ribbon (141692), Metallic Foil Doilies (138392), Stampin Trimmer (126889), Stampin' Dimensionals (104430), and Glue Dots (103683).
Measurements:
- Card Stock 1: Ultra Thick Whisper White 4 1/8 x 7 1/8
- Card Stock 2: DSP 3 1/8x 3 3/8 (Back Side) Front cut just inside this measurement. (You need two) DSP ½” x 12”
- Layers: Soft Sky 2 7/8 x 3 ¼, Butterfly DSP layer 3 x 2 5/8, Half a Gold Doily
Instructions:
- Using Stampin Trimmer, Score at ½” and 3 5/8” on the long side. Turn and Score on both Long sides a half inch from the edges. Cut (from the end with no ½ score line) down the score line until the 3” mark. Cut this strip off on both sides.
- Using snips, cut the little tabs to the closest ½” score line. This will make the tabs to form the box base for the note pad.
- Adhere to the front bottom of the holder on the front only the ½ x 12” piece of DSP.
- Using the ¾” Circle punch, punch a half moon in the center front. Continue to adhere this piece all the way around the box base, after you adhere the box base using Glue Dots.
- Layer all three layers DSP, Cardstock, DSP together. Layer on the Front.
- Tie a Bow around the whole front piece.
- Adhere the Back layer of DSP to the back side to hide the ribbon and open ends of the ½” strip of DSP.
- Using the Big Shot and the Sweet and Sassy Heart Framelits, cut a 1 ¾” Heart.
- Cut the doily in half and adhere to the left front under the ribbon.
- Stamp your Phrase using the Sweet Sugarplum Ink Pad and punch out using the Classic Label Punch. Attach to the heart using the mini paper clips. Adhere heart to the Front using Dimensionals.
- Stamp your Love Note and Cut out using the Big Shot and Love Note Framelits. Also cut a Shadow from the Blushing Bride Glimmer. Adhere using Glue Dots.
- Adhere your note pad in place.
|
Sealed with Love (Occasions catalog, page 15) |
|
Love Notes Framelits Dies (Occasions catalog, page 14) |
Don't forget to come back later today for my Day 6 Fourteen Days of Love Project! Thanks so much for stopping by! Have a great day!
~Today's Thought~
|
|
No comments:
Post a Comment
Thank you for your comments....they are always such an encouragement!